Wolf L582212 Spezifikationen Seite 1

P RO S ERIES H OOD L INERS I NSTALLATION I NSTRUCTIONS

10INSTALLATIONStep 6: Install WiringWARNINGBefore servicing or cleaningunit, switch power off atservice panel and lock theservice disconnecting meanst

LBLOWER-120INT (805087)InstallationIMPORTANT NOTE: Wolf recom-mends installing the internal blowerto the rough-in plate assembly priorto installing li

12REMOTE BLOWERIMPORTANT NOTE: Before turningthe power on, make sure the bloweris in the "OFF" position. Use wire con-nectors or wire nuts a

13P RO S ERIES V ENTILATION H OOD L INER A CCESSORIESBLOWERSInternal Blowers• 805347 – 600 CFM internal blowerfactory installed with ModelL282212I.• L

14SERVICEINFORMATIONIMPORTANT NOTE: If the ventilationhood liner does not operate properly,follow these troubleshooting steps:• Verify that power is b

The information and images are the copyright property of Wolf Appliance Company, LLC,an affiliate of Sub-Zero Freezer Company, Inc. Neither this book

WOLF APPLIANCE COMPANY, LLCP. O. Box 44848 •Madison, WI 53744 •800-332-9513www.wolfappliance.com805049 REV-C 9/03

2I MPORTANT I NFORMATIONIMPORTANT NOTE: This appliancemust be installed in accordance withNational Electrical Codes, as well asall state, municipal an

3P RO S ERIES V ENTILATION H OOD L INERSPro-Series Hood Liner Top Width Overall Dimensions(28-3/8", 34-3/8", 40-3/8", 46-3/8" and

INSTALLATIONCONSIDERATIONS1) A straight, short duct run willallow the hood liner to perform moreefficiently. Try to limit the number ofelbows and tran

Decorative HoodsA decorative hood can be created outof wood, plaster, tile or metal.The decorative hood and Wolf linermust fit at the bottom edge in b

6Width Height of To Center of To Center ofModel Number of Liner (A) Transition (B) Transition (C) Transition (D)L282212I 283/8" (721) 71/2"

CL** DIMENSION IS 2"161/2"31/4"71/16"13/16"11/16"**CL71/2"163/4"31/4"8" ROUND165/8"31/4"7I

4) Attach transition to existing duct-work with sheet metal screws. Useduct tape or silicone to make alljoints secure and air tight.5) If installing a

Step 5: Install the Hood Liner1) Align both ends of the linerassembly with the ends of the rough-in plate.2) Insert the back ends of the linerassembly