Wolf DCX-1000I Spezifikationen PDF herunterladen (Seite 67)

3-44

Section3►Operation

LENS VARISCOPE SYSTEM (LVS™) CALIBRATION

This option allows you to choose between three types of lens calibrations. Reference calibration

determinesareferencepointthatisusedasadenedstartingpositionforrelativemotionofthe

lens. All positioning is measured from this reference point. A reference calibration is lost when

power is removed from the projector and will occur on every power up as long as LVS™ is

enabled. A Motion calibration determines the characteristics of each motor and values are saved

in the projector’s memory. If LVS™ is enabled and a motion calibration has previously been

done, the projector will automatically recall these settings from memory when it’s being powered

up and a motion calibration will not take place. A Full calibration performs both a reference and

motion calibration.

AUTOMATIC LVS LENS CALIBRATION

When this option is selected (default) and the projector is in LVS mode, the projector will perform

a lens calibration on each power-up. During calibration, the shutter will be closed and the status

LED will display ‘LC’. If LVS is not selected, the ALC setting will be ignored. If, during power-up,

ALC is not selected and LVS is, the last stored location from the previous LVS calibration will be

assumed to be true and the lens will moved to that position upon power-up if necessary.

NOTE: It is recommended to leave this feature disabled.

The two “Option Card” entries In the Display Setup menu identify which optional input modules

(a.k.a. cards) are present at INPUT 5 (Option 1) and INPUT 6 (Option 2). If either of these

option slots is empty, the corresponding read-only menu entry does nothing. If there is a module

installed, the corresponding menu entry may activate a submenu of further options pertaining to

that module.

For example, if the Dual SD/HD-SDI module is installed at INPUT 5 (Option 1). The Option

1Cardsubmenuprovidescontrolsforconguringthevariousconnectionsonthismulti-input,

multi-output module.As desired for your application, you can dene 1) which physical input

loops through to which output, and 2) which functional input (main or PIP signal) loops through

to which output.

Select Automatic mode or a series of manual modes. In Automatic mode the input video payload

information is read and compared to that of the SMPTE 352 standard to detect the dual link

format and the primary channel. Single video input will also work in this mode without any

payload information. Dual link input video which does not contain payload information must be

set up manually. Select the format and which of the two channels is the primary input.

System Conguration

OPTIONAL INPUT MODULES

Input A to C, Input B to D

Input A to D, Input B to C

Main to C, PIP to D

Main to D, PIP to C

Loop Thru Output Selection

Configure Channels

Option C ard 1: Dual S D/HD-S DI Module

Input A to C, Input B to D

Automatic

System Conguration

CONFIGURE CHANNELS

- SUBMENU

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 150 151

Kommentare zu diesen Handbüchern

Keine Kommentare

Wolf DCX-1000I Spezifikationen Seite 67

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Wolf DCX-1000I