Wolf ICBDD30 Installationsanleitung PDF herunterladen (Seite 5)

wolfappliance.com

To mount the internal blower on the front of the downdraft

but discharge from the rear:

1 Remove the blower from the blower box.

2 Mount the blower motor to the downdraft using the two

screws provided.

3 Remove the blower plug from the downdraft receptacle

and insert it into the blower receptacle. Refer to the illus-

tration below.

4 Once the plug is installed and the blower secure, install

the blower box to the downdraft using the four screws

provided.

5 Remove the 152 mm collar from the blower box and

solid cover from the rear of the downdraft, then reinstall

the 152 mm collar on the rear and solid cover on the

blower box. Refer to the illustration below.

Installation

INTERNAL BLOWER

To mount the internal blower on the front or rear of the

downdraft:

1 Rotate the blower box so the 152 mm round discharge

is properly located, then disconnect the cable from the

downdraft receptacle and connect it to the blower recep-

tacle. Refer to the illustrations below.

2 Once the blower connection is made and the discharge

properly located, secure the blower to the downdraft

using the four screws provided.

INSTALLATION

DOWNDRAFT

RECEPTACLE

BLOWER

RECEPTACLE

COVER

COLLAR

Blower mounting.

Install cover.

DISCHARGE

DOWNDRAFT

RECEPTACLE

BLOWER

RECEPTACLE

Left, right or bottom discharge.

Blower connection.

REMOTE BLOWER

1 Insert the electrical supply from the remote blower

through the opening on the downdraft and secure using

an approved cord strain relief.

2 Connect hot to brown, neutral to blue and ground to

green. Refer to the illustration below.

WIRING

COVER

POWER CORD

RECEPTACLE

BLUE

BROWN

NEUTRAL

GROUND

HOT

Wiring location.

Remote blower wiring.

COUNTERTOP MOUNTING

Place the downdraft in the opening, then secure the bottom

brackets to the cabinet base using the wood screws pro-

vided. Once the brackets are secure, tighten the existing

lower bracket screws. Refer to the illustration below.

Secure the top mounting brackets to the countertop using

the wood screws provided. For solid surface countertops,

silicone may be used but is not provided.

Once the top is secure, install the undercounter brackets

using the screws provided then install the side covers. Refer

to the illustration below.

MOUNTING

SCREW

COVER

Countertop mounting.

Cover installation.

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Wolf ICBDD30 Installationsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Wolf ICBDD30