Wolf PW302418 Installationsanleitung PDF herunterladen (Seite 14)

Pro Wall Hood Installation 14

IMPORTANT NOTE: R

emove packaging material used to

prevent flap damage during shipping. Damper will not

function properly unless this material is removed prior to

mounting the hood.

5) For internal blowers, mount blower to mounting studs

using nuts supplied with blower. Refer to the illustration

below.

6) Turn back panel assembly upright and reattach using

screws previously removed.

7) Mount damper and two hold-down brackets to the top

of the hood. Damper drops into place and damper

tongues drop into slots on the back panel. Hold-down

brackets clamp on the damper groove overhang.

Secure hold-down brackets using two screws per

bracket. Refer to the illustration below. Seal with

aluminum tape or high temperature duct tape to ensure

a tight seal.

DAMPER

Damper inside hood. Remove damper.

HOLD-DOWN

BRACKET

PACKAGING

MATERIAL

BACK PANEL

MOUNTING

STUD

Mounting stud location. Mount damper.

HOLD-DOWN

BRACKET

DAMPER

ELECTRICAL BOX

Framing must be able to support the weight of the hood

and internal blower, if applicable.

24" and 27" Deep Wall Hoods

WALL PREPARATION

Minimum 2" (51) x 4" (102) lumber is required to construct

wall framing.

HOOD PREPARATION

Install internal blower prior to mounting hood (if applicable).

1) Hood is shipped with back panel in place. Damper is

attached upside down to inside top surface of back

panel. Damper must be removed and reinstalled in the

proper position. Refer to the illustration below.

2) To remove filters, press upward then rotate bottom

outward. To aide in removal, remove center filter first.

Remove grease cups from bottom edge of hood.

Gloves should be worn when handling filters.

3) Detach back panel and damper assembly from hood

by removing the top and back screws. Do not discard

screws.

4) Turn assembly over and place on a protected work

surface. Separate damper from back panel by

removing the hold-down brackets. Do not discard

brackets and screws. Refer to the illustration below.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Wolf PW302418 Installationsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dunstabzugshauben Wolf PW302418