Wolf TYG48C Bedienungsanleitung PDF herunterladen (Seite 6)

- 6 -

GAS PRESSURE REGULATOR INSTALLATION

Gas regulator pressure is preset at 5” Water Column (W.C.) for natural gas, and 10” W.C.

for propane gas. No further adjustment should be required.

Install the regulator as close to the griddle on the gas supply line as possible. Make sure

that the arrow on the underside of the regulator is oriented in the direction of gas flow to

the griddle (Fig. 1) and the regulator is positioned with the vent plug and adjustment

screw upright (Fig. 2).

Fig. 1

Fig. 2

The supply pressure (upstream of the regulator) should be 7-9” W.C. for natural gas and

11-12” W.C. for propane gas. At no time should the griddle be connected to supply

pressure greater than ½ psig (3.45 kPa) or 14” W.C.

TESTING THE GAS SUPPLY SYSTEM

When the gas supply pressure exceeds ½ psig (3.45 kPa), the griddle and its individual

shutoff valve must be disconnected from the gas supply piping system.

When the gas supply pressure is ½ psig (3.45 kPa) or less, the griddle should be isolated

from the gas supply system by closing its individual manual shutoff valve.

GRIDDLES MOUNTED ON STANDS WITH CASTERS

Griddles mounted on stands with casters

must use a flexible connector (not supplied) that

complies with the Standard for Connectors for Movable

Gas Appliances ANSI Z21.69•CSA6.16, and a quick-

disconnect device that complies with Gas Fuel, ANSI

Z21.3•CSA6.9. In addition, adequate means must be

provided to limit movement of the appliance without

depending on the connector and the quick-disconnect

device (or its associated piping) to limit appliance

movement. Attach the restraining device at the rear of

the griddle as shown in Fig. 3.

Fig. 3.

If disconnection of the restraint is necessary, turn off the gas supply before

disconnecting. Reconnect the restraint prior to turning the gas supply on and returning

the griddle to its installation position.

Casters are only supplied on a griddle stand. If the griddle is moved for any reason the

griddle should be re-leveled (see LEVELING in this manual).

1 2 3 4 5 6 7 8

Keine Kommentare

Wolf TYG48C Bedienungsanleitung Seite 6