Wolf TYG48C Bedienungsanleitung PDF herunterladen (Seite 7)

- 7 -

FLUE CONNECTIONS

DO NOT obstruct the flow of flue gases from the flue slots, located around the outside

perimeter of the griddle. It is recommended that flue gases be ventilated to the outside of

the building through a ventilation system installed by qualified personnel.

From the termination of the flue to the filters of the hood venting system, a minimum

clearance of 18” must be maintained.

Information on the construction and installation of ventilating hoods may be obtained from

the standard for “Vapor Removal from Cooking Equipment”, NFPA No. 96 (latest edition),

available from the National Fire Protection Association, Batterymarch Park, Quincy, MA

02269.

ADJUSTMENTS

LEVELING

The griddle must be level (side-to-side and front-to-back) during operation to ensure

proper performance. Improper leveling can result in uneven temperature distribution.

1. Place a level on the griddle.

2. Adjust level by turning the bolts on the bottom of the unit. Using pliers or a crescent

wrench, turn the bolts counter-clockwise to increase height, and clockwise to decrease

height until leveling is achieved.

PILOT ADJUSTMENT

Using a flathead screwdriver, turn the slotted hex-head pilot adjustment screw clockwise

to decrease the flame, and counterclockwise to increase the flame. Pilot adjustments

should only be performed by qualified Service Personnel.

OPERATION

The griddle and its parts are hot. Use care when operating,

cleaning or servicing the griddle

LIGHTING INSTRUCTIONS

1. Turn gas shutoff valve and burner valve to the OFF position and wait 5 minutes.

2. Turn gas shutoff valve ON. Light the pilot adjacent to the main burner. Adjust the pilot

valve screw until the pilot flame has a slight yellow tip.

3. After the pilot has been established, turn the burner valve to the ON position. The

burner flames may be adjusted, using the air shutter on the burner inlet.

4. If the burners fail to light, turn off all valves, wait 5 minutes and repeat steps 1-3.

5. To shut down, turn the burner valves to the OFF position.

1 2 3 4 5 6 7 8

Keine Kommentare

Wolf TYG48C Bedienungsanleitung Seite 7