
11
INSTALLATION INSTRUCTIONS
25
1
/2"min
(648)
26"min (660)
CABINET DEPTH
*Dimension may vary by
+_
1
/8" (3).
**Refer to installation instructions provided with the integrated drawer front (WDFRONT/I) for accurate placement of the anti-tip block.
NOTE: Refer to the built-in 36" (914) single oven specifications for electrical location.
NOTE: The width of the custom panel for the warming drawer with integrated drawer front will vary according to the specific installation,
but the rough opening width will remain 29
15
/16" (760).
NOTE: At installation, wood cleats must be added to the opening for the microwave trim.
2
3
/8"
(60)
10
3
/8"*
(264)
33
3
/8" (854)
MICROWAVE
OPENING WIDTH
24"min
(610)
24
1
/16"
(611)
34
1
/2" (876 )
36-INCH OVEN
OPENING WIDTH
5"
(127)
4"
(102)
E
39" (
991)
RECOMMENDED CABINET WIDTH
36"min (914)
1"min
(25)
20
1
/8"min
(511)
18
11
/16"
(475)
2"(51) x 2"(51)
ANTI-TIP BLOCK**
E
5"
(127)
4"
(102)
29
15
/16"* (760)
WARMING DRAWER
OPENING WIDTH
INSTALLATION SPECIFICATIONS – MODEL SO36U
Installation shown above is with convection microwave with 36" (914) trim and warming drawer with
integrated drawer front.
Dimensions in
parentheses are
in millimeters
unless otherwise
specified.
Keep the bottom foam in place when moving
or carting the oven. The bottom foam also
p
rotects the factory-installed trim.
IMPORTANT NOTE:
Before moving the oven,
protect any finished flooring with appropriate
materials to avoid damage to the floor.
Remove and discard all packing materials,
including cardboard and tape on the outside of
the oven and inside the oven cavity.
Do not remove the bottom foam until
oven has been positioned next to the
installation opening.
UNPACK THE OVEN
Cut the plastic straps and remove the two
V-boards. Remove the four top foam corners
and the corner posts. Remove the carton sleeve
by lifting the sleeve up and over the appliance.
Remove all oven racks, oven rack guides and
broiler pan from inside the oven cavity. For the
double oven, be sure to do this for both the
upper and lower ovens. Remove the four
bottom corners. Use caution as the oven is not
mounted to the shipping base.
Oven is not mounted to the shipping
base. Do not remove banding until the
oven is at the point of installation.
Kommentare zu diesen Handbüchern