Wolf PI363418 Installationsanleitung PDF herunterladen (Seite 11)

Pro Island Hood Installation 11

wolfappliance.com/specs

) The hood assembly is shipped with the transition

attached. The transition is shipped upside down in the

top of the hood and must be removed and reinstalled

in the proper position. Separate the transition from the

hood assembly by removing the four shipping screws.

Invert and reattach the transition to the hood with the

shipping screws.

5) If you are installing an in-line or remote blower, punch

out the knockout hole located on the top of the hood.

Install a wire clamp (provided with hood) for the remote

blower cable. Install another wire clamp in the hole on

top of the hood for the Romex

wire. Refer to the in-

line and remote blowers section on page 16 and follow

installation instructions provided with the blower.

Hood Preparation

) Remove the filters of the pro island hood by pushing

each filter up at the angle it is placed in, and rotate the

bottom of the filter down. Refer to the illustration

below. Gloves should be worn when handling filters.

2) Slide the grease cups out from the bottom edges of the

front and back of the hood.

3) Using a Phillips screwdriver, remove the screws retain-

ing the hood’s internal frame shown in the shaded area

of the illustration below. Be sure to leave the other two

screws in place. Do not discard the screws. They will

be used to reinstall the internal frame after installation

is complete. Remove the internal frame from the hood

and set aside.

FILTER

Remove filters. Internal frame.

REMOVE

SCREWS

DO NOT

REMOVE

DO NOT

REMOVE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Wolf PI363418 Installationsanleitung Seite 11