Wolf C48SS Spezifikationen PDF herunterladen (Seite 15)

TO3%URNERA66E0%L<

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove top burner grates (front and rear) from

the module section being serviced.

2. Remove pilot from mounting clip on the top

burner assembly. Move pilot away from burner

assembly.

)LJ

3. Lift burner heads off the top burner assembly.

4. Lift the top burner assembly at the rear and pull

away from manual valves.

A. Remove pilot mounting clip and flash tube

from the top burner assembly for resuse on

replacement burner assembly.

5. Reverse procedure to install.

NOTE When installing, ensure that each end of the

flash tube is aligned with the ignition ports on the

burner “venturi” casting for proper burner ignition.

)LJ

6. Check for proper operation.

7. Verify

BURNER AIR SHUTTER ADJUSTMENT.

TO3%URNERCONTROL9AL9E

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

)LJ

1. Remove MANIFOLD COVER.

2. Remove TOP BURNER ASSEMBLY.

3. Remove

TOP BURNER PILOT VALVE.

4. Remove top burner control valve from the

manifold.

ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

Page 15 of 33 F45471 (0913)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare

Wolf C48SS Spezifikationen Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Wolf C48SS